STOP/GO LITE Assembly will upgrade any battery charger clamp kit or repair an existing damaged light. A great safety feature for any battery charger. Fits Snugly inside a clamp lever and reads red for no-go, green for go, preventing reverse connection in poorly lit or unreadable conditions.

604592 Associated Booster Cables STOP/GO LITE Assembly. This is the replacement light only (does not include resistor See 604579 for complete kit). For repair of an existing damaged light. A great safety feature for any battery charger. Fits Snugly inside a clamp lever and reads red for no-go, green for go, preventing reverse connection in poorly lit or unreadable conditions.

Associated 605204 Ammeter 0-100 Amp Range w/ Boost. Includes Sealing Gasket, Mounting Template and mounting hardware.

610043 Associated 3/8 Axle Cap (Each)

610052 Associated Axle With Nuts. Axle 3/8" O.D. x 15-3/4" Long

610100 Associated Heatsink Rectifier Kit. The Highest rated Rectifier on the market, completely assembled, includes mounting hardware and insulators.

610175 Fan Motor 220 Volt

610189 Associated Fan Blade Kit, includes two blades with the same diameter, rotation, pitch and wings but differing shaft diameter for older units.

AC CIRCUIT BREAKER

610553 Associated Pair of 7" rubber wheels with a pair of hubs for 3/8" axle.

Discontinued See 610389. Mechanically controls charging in timed Mode with manual hold mode. Two Independant Single Pole Single Throw (SPST) Switches rated 15 amperes. Includes 610931 Knob & (2) #6-20 self-tapping, thread-cutting (type 25) screws.

*If your unit has an Older 90 Minute mechanical timer, use the 611254 retrofit kit to simplify the install. If your unit has an electric 120 minute timer, use the 611245 which is a direct replacement for those units.

610560 Associated 8 Position Rotary Selector Switch With Knob

BREAKER KIT

DC CABLE KIT W/ CLAMPS

611254 Associated 120 Minute Electronic Timer with Knob, retrofit for units with a mechanical timer. The timer controls battery charging in timed Mode and has a manual hold mode for longer charging cycles. Switch circuits are rated 15 amperes. Termination is designed to accept standard 1/4" spade terminals.

*If your unit has an Older 90 Minute mechanical timer, use the 611254 retrofit kit to simplify the install. If your unit has an electric 120 minute timer, use the 611245 which is a direct replacement for those units.

Need side terminal adapters? Model 6200 fits Associated and most other insulated clamps for easier connections. Side terminal adapters clip easily into place inside the clamp rivit and pull out of the way when not in use.

Professional quality heavy duty 500 amp replacement clamps for all booster cables. Replace Associated clamps or other manufacturer's products with these professional quality insulated clamps. Clamps incorporate Associated's innovative "Flexi-Spring" for long cable life at the point it bends most. Possibly the best clamp in the industry.