194 TPI True RMS 50,000 Count DMM W/ Cat IV 1000V Rating W/ A106 And GK13M

Product Features

0.05% basic DCV accuracy
50,000 count display
CAT IV 600 Volts
True RMS DMM
Time Stamp Logging
Optional PC Output with A192
Pulse Width
Duty cycle (% pulse width modulation) for measuring modulating gas valves
Data logging
50,000 count display
0.05% DCV basic accuracy
Inductance, Frequency and Capacitance
0 to 750 ACV; max resolution 100uV
0 to 1,000 DCV: max resolution 0.001mV
0 to 50MΩ; max resolution 0.01Ω
Audible continuity
AC/DC amps up to10 amps; resolution 0.01 uA
Analog bar graph
cULus 61010-1
CATIII-1000VC, CATIII-1000V, CAT IV-600V, CAT III 1000V

Model 194 Applications

Thermocouples in furnaces or gas applications
Heat anticipator current in thermostats
Line voltage
Control circuit voltage
Flame safeguard control current
Heating element resistance (continuity)
Compressor winding resistance
Contactor and relay coil resistance
Continuity of wiring
Motor start and run capacitance
Frequency on controls and line voltages
Record min/max voltage of controls and line voltages
Temperature with optional temperature adapter (A310)
Bar graph to indicate rapid fluctuations in measurements
Voltage of direct drive DC motors
Measure power supply voltage
Match components
Compare readings in circuits and components
Frequency of line and control voltage

Category Ratings:

Category I: Usually electronic equipment or equipment where measures have been taken to limit transient over voltages.

Category II: Single phase loads like appliance personal computers, television sets, and other household loads. Outlets located more than 30 feet froma CAT III source or more than 60 feet from a CAT IV source.

Category III: Distribution level fixed installations like distribution panel devices, short branch and feeder circuits, three phase loads, and single phase commercial lighting.

Category IV: Equipment and lines located on the power line side of a service panel or where a low voltage connection is made to utility power

Model 194 Specifications
DC Volts	Maximum Input: 1000V Maximum Resolution: 0.0001mV Accuracy: +/-0.05%
AC Volts	Maximum Input: 1000V Maximum Resolution: 100μμV Accuracy: +/-0.4%
DC Amps	Maximum Input: 10A Maximum Resolution: 0.01μA Accuracy: +/-0.15%
AC Amps	Maximum Input: 10A Maximum Resolution: 0.01μA Accuracy: +/-0.75%
Resistance (Ohms)	Maximum Input: 50MΩ Maximum Resolution: 1mΩ Accuracy: +/-0.05%
Frequency	Maximum Input: 5MHz Maximum Resolution: 0.001Hz Accuracy: +/-0.05%
Capacitance	Maximum Input: 20mF Maximum Resolution: 0.01nF Accuracy: +/-2%
Inductance	Maximum Input: 300mH Maximum Resolution: 0.01mH Accuracy: +/-5%
Temperature (K-Type Thermocouple)	Maximum Input: -54°F to 2462°F (-50°C to 1350°C) Maximum Resolution: 0.1°F / °C Accuracy: +/-2%
Continuity	Audible at less than 10Ω
Diode	3V at 1mA maximum output
Duty Cycle	Maximum Input: 99.9% Maximum Resolution: 0.1%
True RMS Responding	Yes
Conductance	Yes
Pulse Width	Yes
Data Hold	Yes (Two hold system)
Min/Max Record	Yes
Time Stamp Logging	Yes
Relative Mode	Yes
Compare Mode	Yes
RS-232 Output	Yes, Optically Isolated
Process Loop Output	No
Sleep Mode / Auto Off	Yes
Protective Boot	Yes (standard)
Display Type	50,000 count backlit LCD with dual sub displays and analog bargraph
Range Selection	Auto / Manual
Operating Temperature	32°F to 113°F (0°C to 40°C)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Humidity	80% non-condensing
Size	8.3” x 3.7” x 1.9” (210mm x 95mm x 47mm) without boot 8.7” x 4.3” x 2.6 (220mm x 110mm x 65mm) with boot
Weight	1.3lbs (570g) without boot 1.9lbs (850g) with boot
Battery Type	9V Alkaline (NEDA 1604)
Battery Life	50hrs Typical
OverInput Category	CAT III 600V
Agency Approval	cULus 61010-1, IEC 61010-1
Warranty	Limited Lifetime

Automotive tools & equipment

HVAC & Industrial supplies

Sales - parts -service