This Knob is for selector switches on SE Series chargers only, there are separate knobs for selector switches and timers. Please check your part numbers carefully.

Mechanically controls charging in timed Mode with manual hold mode. Single Pole Single Throw (SPST) Switch rated 15 amperes. Termination is designed to accept 1/4" spade terminals.

0099000096 Knob For Timer Switches 1/4" OD 3/4 "D" Shaft, there are separate knobs for selector switches and timers. Please check your part numbers carefully.

This Knob is for selector switches with a 3/4 Shaft only, there are separate knobs for timers with a half shaft. Please check your part numbers carefully.

0099000471 Wheel 7" X 1.75" hub thickness x 1/4" offset brick tread for 3/8 Axle. See 2199700006 for Axle end cap.

0099000474 Wheel Hub Cap For Wheel (Sold Each)

6 Position Rotary Selector Switch, 7 wire new style.

1199005112 Schumacher Foot, Metal, no hardware included. For 8" Wheeled units.

Axle End Cap Fits .375 (3/8") Diameter Axle, Sold as a Pair, Can be used on any 3/8" Axle to secure wheels.

Fan Motor provides cooling for the unit. 80mm x 80mm x 25mm 12volt DC quite design keeps noise to a minimum. May require the purchase of a 2299001542 Schumacher 12volt DC Fan Speed Controller. Note plug end to determine correct fit. *Please note: You may have to swap plug ends from your old fan.

2299001754 Schumacher Control Board Assembly PSW-70300A. This board requires installation and does not include any hardware rivets etc. It is recommended you also purchase 1 of a 240000077 Silicone Heat Transfer Compound 4 gram for proper heat transfer.

Fan Motor provides cooling for the unit. 80mm X 80mm X 25mm 12volt DC quite design keeps noise to a minimum. If equipped, check your 2299002070 Schumacher 12volt DC Fan Speed Controller for possible fault as well.

3899001556 Schumacher Negative 4 Gauge Output Cable and Clamp

3899001929 Schumacher Positive (Red) Cable & Clamp 4 Ga. 79"

3899001930 Schumacher Negative (Black) Cable & Clamp 4 Ga. 86"

Circuit Breaker 32 Volt DC 120 Amp, Automatic Reset with Screw Terminal Tab Connectors, No Hardware Included. When ordering, it may be necessary to purchase a pair of the 5199000406 screws if replacing and older circuit breaker for retrofit.

Fan Motor provides cooling for the unit. 80mm x 80mm x 25mm 12volt DC Quiet design keeps noise to a minimum. May require the purchase of a 2299001542 Schumacher 12volt DC Fan Speed Controller. Note plug end to determine correct fit. *Please note: If replacing the 2299001565, you may have to swap plug ends from your old fan to make the new fan work. See 169116-001 for connectors

5100000005 Screw M3 X 5.5 For Original Timer

Ammeter Horizontal 0-70 AMP features easy snap-in installation, no tools required. Black Charge Rate face. 0-70 Amp range with start. Wire through induction pick-up for greater accuracy.

Horizontal Panel Mount Volt Meter. 5-16 Volt Range, Battery Percent Of Charge Scale and Alternator Test Scale. Bad - Weak - Good. 4 Point Snap In Mount. 1/4" Spade Terminals. Circuit Board Installed.

6094K89 Knob For Battery Charger Selector Switches & Timers. This Knob is for selector switches and timers, designed with 1/4" ID and a set screw for locking onto shaft. Suitable for all 1/4" shaft switches. Replaces Schumacher 0099000045 & 0099000096.

TJ1-120MB Universal Mechanical 2 Hour Timer With Finish Bell. Mechanically controls charging in timed Mode, has "Hold" for manual un-timed charging. Single Pole Single Throw (SPST) Switch rated 15 amperes. Termination is designed to accept 1/4" Quick Disconnect terminals. Includes mounting screws. Replaces many older mechanical timers.