JUST (1) IN STOCK
Manchester Tank 30lb. 1/4 Flare Refillable Refrigerant Tank 400 PSI Red Vapor Blue Liquid. Universal Gas Refillable Refrigerant Tank. Red Vapor Blue Liquid Ported Valve. 3/4" Plugged Port For Float. 30 lb. capacity refrigerant tank for R-12, R-22, R-502, R-404A, R-410A etc.. (universal) with 1/4" Flare fittings. (Transport Canadian Approved)

These gaskets fit 1/4" flare and 1/2 ACME standard hose fittings. If you are doing maintenance on you unit it's a good idea to replace these as well as they become crushed over time resulting in poor flow or restriction due to swelling. These are standard for some other vendors hoses as well.

Low Side Universal Replacement Compound Gauge -30" to 120 Psi/Bar, Psi/kPa pressure readings, R-22 and R-134a temperature readings in degrees Celsius, Replaces 11692. General usage gauges for multiple applications where pressure or vacuum readings are required. Dampening helps reduce excessive needle fluttering making the gauge much easier to read. Internal components are compatible with many industry applications. The ability to recalibrate the gauge is a standard feature on all gauges. Temperature scale reads in °F and pressure is displayed in either PSI or BAR.

11795 Robinair High Side Refrigerant Manifold Gauge R22/134A 0 To 500 Psi/Bar pressure readings, R22/134A 0 To 500 Psi/Bar temperature readings. General usage gauges for multiple applications where pressure or vacuum readings are required. Dampening helps reduce excessive needle fluttering making the gauge much easier to read. Internal components are compatible with many industry applications. The ability to re-calibrate the gauge is a standard feature on all gauges. Temperature scale reads in °F and pressure is displayed in either PSI or BAR. Replaces 11693

Replacement gauge lens, quarter turn on-off. Designed for ashcroft style gauges. Made of durable lexan for long life. 2.75" diameter.

• Robinair: 12134, 17500, 17700, 17800 series, 25150, 25175, 25200 series

50Lb. Refillable Refrigerant Tank Float Switch. Red Vapor Blue Liquid Ported Valve. 50 lb. capacity refrigerant tank for R-12, R-22, R-502 (universal) with 1/4" Flare fittings

30 Lb. Refillable Refrigerant Tank Float Switch. Red Vapor Blue Liquid Ported Valve. 30 lb. capacity refrigerant tank for R-12, R-22, R-502 (universal) with 1/4" Flare fittings

Power Cord - 110 Volt 16 Gauge. For heay duty cord see 551628.

These gaskets fit 1/4" flare and 1/2 ACME standard fittings. If you are doing maintenance on you unit it's a good idea to replace these as well as they become smashed over time resulting in poor depression on the schreader fitting causing low flow or restriction due to swelling.

Main Power Switch Controls the power between the power cord and the main board.

60" Blue Standard Fitting (1/4" FFL) Enviro-Guard Hose is rated at 740 psi working pressure, 3700 psi burst pressure. Designed for today's High Pressure Refrigerants. Features an In-line ball valve for positive shut off preventing blow back when removing or installing them. Enviro-Guard Hoses are constructed of special barrier material which prevent virtually any permeation of refrigerant, yet remains flexible. Meet all specifications for low permeation construction.  740 psi working pressure, 3700 psi burst pressure.

60" Red Standard Fitting (1/4" FFL) Enviro-Guard Hose is rated at 740 psi working pressure, 3700 psi burst pressure. Designed for today's High Pressure Refrigerants. Features an In-line ball valve for positive shut off preventing blow back when removing or installing them. Enviro-Guard Hoses are constructed of special barrier material which prevent virtually any permeation of refrigerant, yet remains flexible. Meet all specifications for low permeation construction.  740 psi working pressure, 3700 psi burst pressure.

CRXTOSP1 Tank Overfill Protection Cable Shorting Plug allows the user to override the tank float safety device on most recovery units using a 3 pin brad Harrison cable. Screws in place at the cable end allowing the unit to start. (Always use a scale for accuracy when using this device) 30 & 50 pound tanks should never be filled to a level beyond 80% of tank capacity.

1/4 Flare Seal Cap with anchor retention strap prevents loss when not in use.

Red Light High Pressure Light / Tank Full Light - Indicates when the discharge pressure reaches 350 psi or when the recovery tank is full.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Fan Used to keep the unit hermetic compressor and electrical components cool.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

System Relay 115 volt coil, double pole single throw normally open switch with dual sets of 15 amp contacts. Acts as a pilot from the circuit board usually carrying higher amp loads to protect smaller relays on board. Can be used for universal applications due to the high amp contact rating.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Ball Valve Assembly A manual valve that, when open, routes discharge pressure through the condenser.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Complete Refrigerant Solenoid Assembly (120v) Includes brass body and coil. A normally closed solenoid that, when energized, allows flow. i.e. Recovery, Charge, vacuum, etc. NOTE: RA19258 Solenoid Rebuild Kit
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Recovery Switch Opens the recovery solenoid and allows the compressor to run.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

High Pressure Cutout 17650 / 17655 A normally closed sensor that opens, stopping the recovery process when the compressor discharge pressure reaches 435 psi. SPDT Contact arrangement. 1/4 spade termination.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Float Relay Interrupts power from the system relay. The Tank Full light comes on when the float opens the circuit.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Check Valve Allows flow in one direction only and prevents pressure from back flowing into a particular path.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Optical Sensor constantly monitors refrigerant state, and switches the recovery mode circuit from liquid to vapor for the most efficient recovery.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Discontinued See RA19484 Oilless Compressor rebuilt kit. 1/3 hp oilless compressor that pumps refrigerant from vehicle being serviced into storage tank.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Float Chamber 25200 Series Monitors incoming refrigerant and automatically switches the unit from liquid recovery to vapor recovery. Earlier units used a liquid/vapor optical sensor.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Start Capacitor Provides a high amperage discharge to aid the compressor in starting.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Main Power Switch Controls the power between the power cord and the main board.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Start Relay When energized, sends voltage to the compressor and start capacitor to complete a circuit to the compressor and allow the compressor to start and run.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Red Light 230v Tank full and high pressure lights. Informs user if tank is full or has high pressure.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Base Plate 25200 Includes base, rubber feet and hardware. RA17668 Rubber Feet (Pkg. of 4)
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

115v Solenoid Coil Coil only, used to energize a normally closed solenoid that, when energized, allows flow. i.e. Recovery, Charge, vacuum, etc. NOTE: RA19258 Solenoid Rebuild Kit
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Float Chamber 17800B Magnetic float switch that sends a signal to the main circuit board when liquid is entering the system. The RA19804 Series bottle switch is a compact, economical liquid level sensing device for external mounting in applications not suited to small, internally-mounted level switches. These single point devices are typically used for low or high level sensing. 1/4" NPT Inlet (Bottle) 1/8" NPT Outlet (Cap).
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.