These gaskets fit 1/4" flare and 1/2 ACME standard hose fittings. If you are doing maintenance on you unit it's a good idea to replace these as well as they become crushed over time resulting in poor flow or restriction due to swelling. These are standard for some other vendors hoses as well.

50lb. R-12 / Universal Gas Refillable Refrigerant Tank. Red Vapor Blue Liquid Ported Valve. 50 lb. capacity refrigerant tank for R-12, R-22, R-502 (universal) with 1/4" Flare fittings

Float Switch Cable Makes the connection between the float in the tank and the system relay. When the tank reaches 80% capacity, the float interrupts the control voltage to the system relay causing the unit to shut down.

Optional Float Cable and Relay assembly for Portable Recovery Units: 25200B 25175A 25150A. Enables recovery units to operate with 80% float tanks. This item has been discontinued, see 19225 Cable & RA19133 relay as replacements.

Rebuild Kit For 110 Dc Oil-Less Compressor

19652 Robinair Oil-Less Compressor For 25150A 25175A 25200B 17800B (Special order item)

Low Side Gauge For 25175a / 25200b

High Side Gauge For 25200b

19685 Robinair Float Chamber For 25200B 25201B 25202B

Manifold Assembly For 25200b / 25202b

Spool Valve 25XXX Series Units

Robinair Switch Recover / Self Clear

These gaskets fit 1/4" flare and 1/2 ACME standard fittings. If you are doing maintenance on you unit it's a good idea to replace these as well as they become smashed over time resulting in poor flow.

Main Power Switch Controls the power between the power cord and the main board.

CRXTOSP1 Tank Overfill Protection Cable Shorting Plug allows the user to override the tank float safety device on most recovery units using a 3 pin brad Harrison cable. Screws in place at the cable end allowing the unit to start. (Always use a scale for accuracy when using this device) 30 & 50 pound tanks should never be filled to a level beyond 80% of tank capacity.

1/4 Flare Seal Cap with anchor retention strap prevents loss when not in use.

Red Light High Pressure Light / Tank Full Light - Indicates when the discharge pressure reaches 350 psi or when the recovery tank is full.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Fan Used to keep the unit hermetic compressor and electrical components cool.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Float Relay Interrupts power from the system relay. The Tank Full light comes on when the float opens the circuit.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Manifold Bypass Check Valve Prevents flow to the manifold bypass solenoid during the recovery, recycling, and charging modes.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Main Power Switch Controls the power between the power cord and the main board.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Float Chamber 17800B Magnetic float switch that sends a signal to the main circuit board when liquid is entering the system. The RA19804 Series bottle switch is a compact, economical liquid level sensing device for external mounting in applications not suited to small, internally-mounted level switches. These single point devices are typically used for low or high level sensing. 1/4" NPT Inlet (Bottle) 1/8" NPT Outlet (Cap).
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.