• Robinair: 12134, 17500, 17700, 17800 series, 25150, 25175, 25200 series

19299 Robinair 36" Yellow Quick-Seal Enviro-Guard Tank Hose 1/4" Flare For R-12 and other gasses. Enviro-Guard Hoses are constructed of special barrier material which prevent virtually any permeation of refrigerant, yet remains flexible. Quick-Seal Fittings prevent pressure release when disconnected form their fittings

19375 Robinair 36" Blue Quick-Seal Enviro-Guard Tank Hose 1/4" Flare for R12 and other gasses. Enviro-Guard Hoses for Automotive R-12. Enviro-Guard Hoses are constructed of special barrier material which prevent virtually any permeation of refrigerant, yet remains flexible. Meet all specifications for low permeation construction.  740 psi working pressure, 3700 psi burst pressure.

These depressors fit behind and protrude through the hose gasket on 1/4" flare and 1/2 ACME standard fittings. If you are replacing hose gaskets it's a good idea to replace these as well as they become smashed over time resulting in poor depression on the schreader fitting causing low flow.

These gaskets fit 1/4" flare and 1/2 ACME standard fittings. If you are doing maintenance on you unit it's a good idea to replace these as well as they become smashed over time resulting in poor depression on the schreader fitting causing low flow or restriction due to swelling.

68336A Robinair 36" Red Enviro-Guard Hose 45 Degree Quick Seal Fitting 1/4" Flare for R-12 and other gasses. Enviro-Guard Hoses are constructed of special barrier material which prevent virtually any permeation of refrigerant, yet remains flexible. Meet all specifications for low permeation construction. 740 psi working pressure, 3700 psi burst pressure.

This 1/4" Flare Oil Injector Assembly Allows for the storage 8 ounces and injection of oils and dyes into the A/C system with out permitting air to enter into the system. It attaches directly to the inlet fitting of any recovery unit and can be left permanently installed. Features full flow of refrigerant and will not impede charging or recovery. Simple operation makes this injector the first choice for heavy dyes and oils with out damaging your recovery system. Simply recover the A/C system or pull a deep vacuum and then inject the desired amount of oil and chase with a charge. The injector cannot be pressurized even if left open due to a integrated check valve assembly for safety. 1/4" Flare QuickSeal fitting at the machine end and a 1/4" Flare Male fitting for the hose connection. 8 ounce oil bottle and a level ring for convenience.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.