These gaskets fit 1/4" flare and 1/2 ACME standard hose fittings. If you are doing maintenance on you unit it's a good idea to replace these as well as they become crushed over time resulting in poor flow or restriction due to swelling. These are standard for some other vendors hoses as well.

Optional Vacuum Pump Intake Fitting Adapter. Brass Construction. 3/8" Female Flare x 1/4" Male Flare

8oz. Graduated Oil Drain - Oil Injector Bottle. 8oz Capacity in 1/2oz graduations and 240 Milliliters in 10 Milliliter graduations, for dispensing oil via an injector or for measuring oil removed during refrigernt recovery process.

50lb. R-12 / Universal Gas Refillable Refrigerant Tank. Red Vapor Blue Liquid Ported Valve. 50 lb. capacity refrigerant tank for R-12, R-22, R-502 (universal) with 1/4" Flare fittings

50 Lb. Refillable Refrigerant Tank Float Switch. Red Vapor Blue Liquid Ported Valve. 50 lb. capacity refrigerant tank for R-12, R-22, R-502 (universal) with 1/4" Flare fittings

30 Lb. Refillable Refrigerant Tank Float Switch. Red Vapor Blue Liquid Ported Valve. 30 lb. capacity refrigerant tank for R-12, R-22, R-502 (universal) with 1/4" Flare fittings

Power Cord - 110 Volt 16 Gauge. For heay duty cord see 551628.

Float Switch Cable Makes the connection between the float in the tank and the system relay. When the tank reaches 80% capacity, the float interrupts the control voltage to the system relay causing the unit to shut down.

3/8" Quick Seal Repair Kit for Enviro-Guard Hoses rebuilds leaking or damaged Quick Seal Enviro-Guard Hoses. Kit includes complete instructions and installs in minutes

36" Blue Enviro-Guard Hose 1/2" Fl Fittings QUICK SEAL - DISCONTINUED

These gaskets fit 1/4" flare and 1/2 ACME standard fittings. If you are doing maintenance on you unit it's a good idea to replace these as well as they become smashed over time resulting in poor flow.

Enviro-Guard Hoses are constructed of special barrier material which prevent virtually any permeation of refrigerant, yet remains flexible. Meet all specifications for low permeation construction. 740 psi working pressure, 3700 psi burst pressure.

Enviro-Guard Hoses are constructed of special barrier material which prevent virtually any permeation of refrigerant, yet remains flexible. Meet all specifications for low permeation construction. 740 psi working pressure, 3700 psi burst pressure.

CRXTOSP1 Tank Overfill Protection Cable Shorting Plug allows the user to override the tank float safety device on most recovery units using a 3 pin brad Harrison cable. Screws in place at the cable end allowing the unit to start. (Always use a scale for accuracy when using this device) 30 & 50 pound tanks should never be filled to a level beyond 80% of tank capacity.

1/4 Flare Seal Cap with anchor retention strap prevents loss when not in use.

Fan Used to keep the unit hermetic compressor and electrical components cool.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

System Relay 115 volt coil, double pole single throw normally open switch with dual sets of 15 amp contacts. Acts as a pilot from the circuit board usually carrying higher amp loads to protect smaller relays on board. Can be used for universal applications due to the high amp contact rating.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Recovery Solenoid Normally closed automatic valve that prevents flow of refrigerant into the system oil separator while not powered.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Fan Used to force air through the evaporator/condenser.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Compressor Oil Separator Separates any oil being carried out of the compressor and returns it to the inlet side of the compressor.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

High Pressure Cutout 17650 / 17655 A normally closed sensor that opens, stopping the recovery process when the compressor discharge pressure reaches 435 psi. SPDT Contact arrangement. 1/4 spade termination.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Liquid Flow Control Meters the flow of refrigerant into the evaporator. It senses the inlet and discharge temperature of the evaporator and automatically compensates the flow to minimize the amount of liquid in the evaporator.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

RA19106 Robinair Main Power Switch Lighted
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Recovery Start Switch 10 Amp 1/4 HP Momentary Orange Lighted Switch
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

RA19108 Robinair Liquid Recovery Switch 115V 60Hz For 17660 Series
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

High Pressure Light Provides a visual warning when high pressure is reached on the discharge side of the compressor.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Tank Full Light Provides a visual warning when the tank is full.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Compressor Pumps the refrigerant from vehicle being serviced into the ISV or tank, on or inside of unit, for storage.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Tank Full Light Provides a visual warning when the tank is full.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Float Relay Interrupts power from the system relay. The Tank Full light comes on when the float opens the circuit.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Float Relay When energized, turns off the compressor and turns on the Tank Full light.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Inlet Fitting
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Discontinued Valve Provides a path for refrigerant to re-enter the base unit.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Start Capacitor Provides a high amperage discharge to aid the compressor in starting.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Run Capacitor Provides a high amperage discharge to aid the compressor in running.
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

Stud & Retainer Kit
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.

RA19181 Robinair 115 Volt Power Cord Receptacle
Robinair does not warrant any "RA" repair item not installed by an Authorized Service Center.