 |
 |
 |
|
Two pack of 3/4'' swivel female flare connector to 3/4'' solder tube by JB Industries (US5-1212).
Solder on flare tube adapters allow the technician to create a flare connection when a flare block is unavailable or will not fit in a tight spot. Fittings are SAE 45° standard flare and tube size is I.D. for standard tube sizes.
Maximum Strength
JB uses the highest level of brass consisting of 65% copper and 35% zinc which means high-tensile strength while resisting corrosion. The forging process of fittings maximize strength and eliminate cracking. Many import fittings use less quality brass with lower copper content and as a result have a much higher failure rate. Vacuum pressures of 5,000 psi can be handled depending on the size, materials, and conditions. Long dryseal pipe threads minimize leakage and provide more clearance for tightening flare nuts.
Flexibility
JB brass fittings can be used with copper, brass, aluminum, steel, and plastic tubes providing an acceptable flare can be generated with the material. JB's heavy-duty ACR tube fittings generally conform to SAE, ASA and ARI standards for marine, hydraulic, and refrigeration service.
Tube fittings are make and break, have good vibration resistance, economical and are easy to assemble. JB will provide flare fitting to SAE standard J513 whenever possible.
Made in the USA
JB Industries machines all brass fittings at their factory in Aurora, Illinois.
 Warning: This product may expose you to chemicals including lead which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
|
|
|
 |
|
 |
|