Automotive tools & equipment

HVAC & Industrial supplies

Sales - parts -service

You are here: Home > Battery Charger Parts > Schumacher Battery Charger Repair Parts > PS-1562A Schumacher Battery Charger Parts List

PS-1562A Schumacher Battery Charger Parts List



Schumacher PS-1562A Repair Parts
Part No.
Description
Qty
0094030008
Battery Charger Ring Terminal Quick Disconnect with Dust Cover
1
0094085881
Battery Charger Ring Terminal Quick Disconnect 18" 3 Amp Fused
1
2299001950
Battery Charger 18" Ring Terminal Quick Disconnect with Dust Cover
1
3899001233
Ring Terminal Quick Disconnect 18"
1
3899001235
Battery Charger Clip Set
1
3899001401
Battery Charger Cigarette Lighter Quick Disconnect
1
EC-25
Battery Maintainer 25ft DC Extension Cord



Schumacher PS-1562A Troubleshooting Guide
PROBLEM POSSIBLE CAUSE SOLUTION
Charger will not turn on when properly connected. AC outlet is dead. Check for an open fuse or circuit breaker supplying the AC outlet.
Poor electrical connec¬tion. Check the power cord and extension cord for as loose fitting plug.
Severely discharged, but otherwise good, battery. The battery may not want to accept a charge due to a run-down state. Allow the charging to continue until the battery has had a chance to recover sufficiently enough to take a charge. If more than 20 minutes, stop charging and have the battery checked.
Clips are not making a good connection to the battery. Check for poor connec¬tion to battery and frame. Make sure connection points are clean. Rock clips back and forth for a better connection.
Battery is defective. Have the battery checked.
Reverse connections at battery. Unplug the charger and correct the lead connec¬tions.
Charger makes a loud buzz or hum. Transformer laminations vibrate (buzz). No problem, this is a normal condition.
Shorted Diode Assembly or Output Rectifier Assembly (hum). Have charger checked by a qualified technician.
CHARGING (yellow) LED is flashing. Indicates the charger is in abort mode. See “Aborted Charge” in the OPERATING INSTRUCTIONS Section.
Schumacher User Manual Link


When a charging problem arises, make certain that the battery is capable of accepting a normal charge. Double check all connections, AC outlet for a full 120-volts, charger clips for correct polarity and the quality of the connections from the cables to the clips and from the clips to the battery system. The clips must be clean.

When a battery is very cold, partially charged or sulfated, it will not draw the full rated amperes from the charger. It is both dangerous and damaging to a battery to force higher amperage into it than it can effectively use in recharging.

Sort By:
Page of 1
0094030008 Schumacher WM-12 Battery Charger 18" Ring Terminal Quick Disconnect With Dust Cover 0094030008 Schumacher WM-12 Battery Charger 18" Ring Terminal Quick Disconnect With Dust Cover

Schumacher WM-12 Battery Charger 18" Ring Terminal Quick Disconnect With Dust Cover, Ring terminal and plug set makes easy access to battery for seasonal charging. Left installed on battery, you can simply plug in and walk away. Designed for permanent connection. Great for hard-to-reach motorcycle batteries. WM-12 Schumacher Ring Adapter Set Fits MC-1 SEM-1562A SC-200A SC-300A

Price $3.95
0094085881 Schumacher Battery Charger Ring Terminal Quick Disconnect 18" 3 Amp Fused 0094085881 Schumacher Battery Charger Ring Terminal Quick Disconnect 18" 3 Amp Fused

Schumacher Battery Charger 3 Amp Fused Quick Disconnect with dust cover. Ring terminal and plug set makes easy access to battery for seasonal charging. Left installed on battery, you can simply plug in and walk away. Designed for permanent connection. Great for hard-to-reach motorcycle batteries. Works On Most Schumacher Small Chargers.

Price $7.93
   
 
*Variations of models due to production changes and parts availability are not our responsibility
*No refunds on electrical components
*Service should be performed only by a qualified technician
*Please read all supporting documentation and safety instructions