100343 PROMAX Filter 1/4 Male Flare
1/4" Flare Filter for ProMax and MiniMax Units Designed to protect recovery systems from debris and deposits that would normally harm your unit. Large filter capacity provides long life. All steel construction with enamel finish resists corrosion and rusting.
518638 Robinair 15 Amp Magnetic Circuit Breaker
518638 Robinair 15 Amp Magnetic Circuit Breaker provides protection of main electrical input. Single Pole 15 Amps 125-250 AC. Mounts Via Snap In Bezel. Terminal Connection 0.250 Spade terminals.
659940 PROMAX Complete Manifold (RG5XXXX)
Inlet Block / Manifold Assembly includes black machined block, valves and old style flat knobs. (Caution! Do turn knobs from there original position before installing or they will lose there indexing and improper flow will result).
Discontinued
700009-A PROMAX Inlet Block / Manifold Assembly
Inlet Block / Manifold Assembly includes black machined block, valves and new knobs. (Caution! Do turn knobs from there original position before installing or they will lose there indexing and improper flow will result)
CRXTOSP1 CPS 3 Pin Brad Harrison Tank Overfill Cable Shorting Plug
CRXTOSP1 Tank Overfill Protection Cable Shorting Plug allows the user to override the tank float safety device on most recovery units using a 3 pin brad Harrison cable. Screws in place at the cable end allowing the unit to start. (Always use a scale for accuracy when using this device) 30 & 50 pound tanks should never be filled to a level beyond 80% of tank capacity.
EL1817 PROMAX Axial Fan
Axial Fan 115 volt, .43 amp 35 watt Rotary Fan, 6.375" Mounting Hole Centers. Two wire lead set for power connection 14" & 24"with 1/4" spade terminals.
GA0800 PROMAX 800psi Gauge (Red)
800psi Gauge (Red), 1/8" MPT Bottom Tap Fitting, 0 To 800 PSI 800 PSI Max Pressure Scale, PSI/BAR pressure readings, R-410a PT Scale
GA1500 PROMAX 500psi Gauge (Blue)
500psi Gauge (Blue), 1/8" MPT Bottom Tap Fitting, -30"HG To 250 PSI 500 PSI Max Compound Scale, PSI/BAR pressure readings, R-410a PT Scale
KT3302 PROMAX Piston Seal Replacement Kit
This PROMAX piston seal replacement kit is to be used on the old style (round cylinder) and new style (rectangle Cylinder) compressors on RG54xx series, MiniMax Series and PROVAC Compressors.
KT3303 PROMAX Compressor Valves And Seal Kit
PROMAX Valve Replacement Kit is to be used on the old style (round cylinder) and new style (rectangle Cylinder) compressors on RG5410 series, MiniMax Series and PROVAC Compressors. Kit includes all necessary parts to rebuild damaged valves and seals.
KT3307 PROMAX Compressor Major Repair Kit (CP1320 Compressors)
This PROMAX piston compressor rebuild kit includes all parts needed to rebuild the new style (Rectangle Cylinder Only) compressors on RG54XX series, MiniMax Series and PROVAC Compressors. Kit includes all necessary parts to rebuild the piston "SLYD" Rings, Square piston seal and cylinder seat seals, as well as all necessary parts to rebuild damaged valves and seals and finally the bearings and shaft seal. This Kit does not include the actual valve plate, we suggest the purchase of the valve plate itself here. This kit will not repair round cylinder compressors.
RG5410EX PROMAX High Pressure Recovery Unit
Designed for EXtremely Fast recovery of medium and high-pressure refrigerants, including R-410A (Puron). Features include automatic 13" Low Pressure Shut off (selectable for deeper recovery), automatic high pressure cut-out switch (selectable for low or high pressure gasses), for safety and a 20% increase in flow over the RG5410A. Direct liquid recovery without damaging the compressor and an Oil-less compressor which allows for rapid transfer of large amounts of liquid.
| Published Recovery Rates |
| Direct Liquid - 4.77 lb/min |
Direct Vapor - 0.41 lb/min |
Push/Pull - 14.5 lb/min |
Discontinued See RG6
Salvage Operation Refrigerant Recovery Unit Starter Kit
Having a hard time keeping up with work flow in a salvage yard or appliance recycling center? Recovering refrigerant can be time consuming and difficult to manage. This exclusive package from Century allows for the recovery of refrigerant from up to 10 appliances at one time making salvage operations quick and easy. Our package solution offers you the ability to recover 100 or more appliances a day making your work easy and profitable. Our trained staff can even custom build one for you tailored to specific needs.
