Associated Pointer Knob with spring clip (Press-On). Fits 1/2 round shaft switches and timers only. For 3/4 round shaft applications see 610930.

STOP/GO LITE Assembly will upgrade any battery charger clamp kit or repair an existing damaged light. A great safety feature for any battery charger. Fits Snugly inside a clamp lever and reads red for no-go, green for go, preventing reverse connection in poorly lit or unreadable conditions.

Associated 605204 Ammeter 0-100 Amp Range w/ Boost. Includes Sealing Gasket, Mounting Template and mounting hardware.

Chrome Handle with screws and insulated clamp bar.

610052 Associated Axle With Nuts. Axle 3/8" O.D. x 15-3/4" Long

610189 Associated Fan Blade Kit, includes two blades with the same diameter, rotation, pitch and wings but differing shaft diameter for older units.

Universal Fan Motor Installation Kit includes everything needed to install on virtually any unit. Comes complete with a 115v. skeleton frame motor (reversible), equipped with 1/4" spade terminals for electrical connections, a fan blade, a set of 1/4" female spade terminal adapter leads, 1/4" Crimp-on female spades for alternate hook up, 2 sets of pin terminals for molex plug installation and 2 wire nuts.

610263 Associated Rocker Switch SPDT

610517 Associated Clamp Bar 7"

DC Circuit Breaker Kit

500 Amp Jaw Kit (Repairs One Clamp) Heavy Duty Copper construction for long life and high conductance. Includes insulators and screws with acorn nuts.

611157 Associated Wheel Kit Rubber 6 Inch

611167 Associated SPDT Switch (On-Off-On)

This kit replaces several older style switch / knob combinations. Simply follow the easy to read instructions for your battery charger and install the knob. Illustrated instructions indicate any wiring changes needed to facilitate the new switch.

Harness 7 Pin Housing

611467 Associated Rectifier #1 ESS6008 ESS6011

611468 Associated Rectifier #2 ESS6008 ESS6011

611470 Associated Fan Relay Board

611481 Associated A/C Power Cord 115 Volt

611493 Associated DC Cable Clamp Set ESS6011

611495 Associated Printed Circuit Board ESS6011

Professional quality heavy-duty clamps for all booster cables. Replace Associated clamps or upgrade other lesser products with these professional quality replacement clamps.

Need side terminal adapters? Model 6200 fits Associated and most other insulated clamps for easier connections. Side terminal adapters clip easily into place inside the clamp rivit and pull out of the way when not in use.

The ESS6011 Associated 70/35/200 Amp 12/24 Volt Automatic Automotive Battery Charger / Power Supply provides safe effective charging at 12 Volt and 24 Volt Flooded / Maintenance Free, AGM, Gel Cell, and Deep-Cycle Batteries, as well as Spiral Cell, Orbital or Optima Batteries. The Electrical Stability System (ESS™) technology turns ESS6011 into a stable power supply for extended service procedures or re-flashes while the battery is removed while maintaining a nominal 13.7V DC Output. The Deep Discharge and Recovery with desulfation mode enables the user to recover dead batteries ultimately saving the cost of the unit over several batteries that would have normally gone to waste.