020-0076 Associated Chrome Handle Screws (Each)

STOP/GO LITE Assembly will upgrade any battery charger clamp kit or repair an existing damaged light. A great safety feature for any battery charger. Fits Snugly inside a clamp lever and reads red for no-go, green for go, preventing reverse connection in poorly lit or unreadable conditions.

604592 Associated Booster Cables STOP/GO LITE Assembly. This is the replacement light only (does not include resistor See 604579 for complete kit). For repair of an existing damaged light. A great safety feature for any battery charger. Fits Snugly inside a clamp lever and reads red for no-go, green for go, preventing reverse connection in poorly lit or unreadable conditions.

Associated 605204 Ammeter 0-100 Amp Range w/ Boost. Includes Sealing Gasket, Mounting Template and mounting hardware.

Chrome Handle with screws and insulated clamp bar.

Front Leg With Screws

610054 Associated Universal Base 6009 (UNIVERSAL BASE 6009 (SEE 610498 Base if transformer has four "L" shaped legs.)

610189 Associated Fan Blade Kit, includes two blades with the same diameter, rotation, pitch and wings but differing shaft diameter for older units.

Universal Fan Motor Installation Kit includes everything needed to install on virtually any unit. Comes complete with a 115v. skeleton frame motor (reversible), equipped with 1/4" spade terminals for electrical connections, a fan blade, a set of 1/4" female spade terminal adapter leads, 1/4" Crimp-on female spades for alternate hook up, 2 sets of pin terminals for molex plug installation and 2 wire nuts.

610263 Associated Rocker Switch SPDT

Universal Base W/Transformer Leg Mounting Holes

610517 Associated Clamp Bar 7"

DC Circuit Breaker Kit

500 Amp Jaw Kit (Repairs One Clamp) Heavy Duty Copper construction for long life and high conductance. Includes insulators and screws with acorn nuts.

610977 Associated Back Panel 19 Black

611011 Associated Top Panel 7 Inch Blue

611031 Associated Left Slope Side Panel 40° Blue

611032 Associated Front Slope Side Panel 40° Blue

611157 Associated Wheel Kit Rubber 6 Inch

611167 Associated SPDT Switch (On-Off-On)

611185 Associated A/C Power Cord 6366

Dc Cable Set

Front Panel ESS6008

Harness 7 Pin Housing

Single Pole Rocker Switch (009-0126)

Front Panel  ESS6008Ms (041-1873)

Rectifier For  ESS6008Ms Diode 6X7.75

Rocker Switch DPDT

Control Circuit Board 12Vdc 60A/270A Boost. (Does not include Fan Relay Board 611470)

611467 Associated Rectifier #1 ESS6008 ESS6011

611468 Associated Rectifier #2 ESS6008 ESS6011

611470 Associated Fan Relay Board

611480 Associated Switch Large Display for IBC6008

Professional quality heavy-duty clamps for all booster cables. Replace Associated clamps or upgrade other lesser products with these professional quality replacement clamps.

Need side terminal adapters? Model 6200 fits Associated and most other insulated clamps for easier connections. Side terminal adapters clip easily into place inside the clamp rivit and pull out of the way when not in use.

The CC6212 Associated Battery Cable Covers are designed for use with Memory Saver Cables or when removing batteries to prevent positive battery clamp from arcing. High Visibility & Corrosive Resistant MADE IN THE USA.

The ESS6008 Associated 60/270 Amp 12 Volt Automatic Battery Charger / Analyzer and Start Assist provides safe effective charging at 12 Volt for Flooded / Maintenance Free, AGM, Gel Cell, and Deep-Cycle Batteries, as well as Spiral Cell, Orbital or Optima Batteries. The Electrical Stability System (ESS™) technology turns ESS6008 into a stable power supply for extended service procedures or re-flashes while the battery is removed while maintaining a nominal 13.7V DC Output.

ESS6008MSK Associated Intellamatic® 12 Volt - 60 Amp / 270 Amp Boost Wheel Automotive Battery Charger and 70 Amp Power Supply with 15 Amp Memory Saver Port for Standard Automotive, Deep‐cycle, AGM and Gel Cell Batteries Includes 12’ Memory Saver Cable and Terminal Covers. The ESS6008 Associated 60/270 Amp 12 Volt Automatic Battery Charger / Analyzer and Start Assist provides safe effective charging at 12 Volt for Flooded / Maintenance Free, AGM, Gel Cell, and Deep-Cycle Batteries, as well as Spiral Cell, Orbital or Optima Batteries. The Electrical Stability System (ESS™) technology turns ESS6008 into a stable power supply for extended service procedures or re-flashes while the battery is removed while maintaining a nominal 13.7V DC Output Via the OBDII Port on your vehicle.

The IBC6008 Associated 60 Amp 12 Volt Automatic Automotive Battery Charger / Analyzer provides safe effective charging at 12 Volt for Flooded / Maintenance Free, AGM, Gel Cell, and Deep-Cycle Batteries, as well as Spiral Cell, Orbital or Optima Batteries. The Electrical Stability System (ESS™) technology turns IBC6008 into a stable power supply for extended service procedures or re-flashes while the battery is removed while maintaining a nominal 13.7V DC Output.

IBC6008MSK Associated Intellamatic® 12 Volt - 60 Amp / 270 Amp Boost Wheel Automotive Battery Charger and 70 Amp Power Supply with 15 Amp Memory Saver Port for Standard Automotive, Deep‐cycle, AGM and Gel Cell Batteries Includes 12’ Memory Saver Cable and Terminal Covers. The IBC6008MSK Associated 60/270 Amp 12 Volt Automatic Battery Charger / Analyzer and Start Assist provides safe effective charging at 12 Volt for Flooded / Maintenance Free, AGM, Gel Cell, and Deep-Cycle Batteries, as well as Spiral Cell, Orbital or Optima Batteries. The Electrical Stability System (ESS™) technology turns IBC6008MSK into a stable power supply for extended service procedures or re-flashes while the battery is removed while maintaining a nominal 13.7V DC Output Via the OBDII Port on your vehicle.

MS6209 ATEC Automotive Memory Saver Cable - This unit helps to prevent the loss of electronic memory when disconnecting the battery and using a power supply. The cigarette lighter / 12Volt accessory adapter can be used with any Associated Kwikstart receptacle and the other end simply connects to the OBDII port on any 1996 or later vehicle.

MS6209-12 ATEC 5 Amp Memory Saver 12Ft. Cable OBDII. Automotive Memory Saver Cable - This unit helps to prevent the loss of electronic memory when disconnecting the battery and using a power supply. The cigarette lighter / 12Volt accessory adapter can be used with any Associated Kwikstart receptacle and the other end simply connects to the OBDII port on any 1996 or later vehicle.