13-504 CPS Capacitor 233-280 MFD 120VAC
30-480 CPS Cap 1/4 SAE Female w/strap
30-734 CPS High Pressure Gauge 0-55 (kPa Bar)
30-735 CPS Low Pressure Gauge -1-20 (kPa Bar)
35-102 CPS Main Power Switch DPST On-Off
35-108 CPS Selector Switch. SPST (On-Off), 16 A 125VAC. 1/4" Quick Connect Terminal. Panel mount, Hole Size: 28.58 mm x 13.97 mm
36-014 CPS Solenoid And Coil Kit 115 Volt. 1/4" Quick Disconnect terminals 5/64" Orifice 300 PSI MOPD, 115 volt coil.
37-106 CPS Compressor Start Relay 4CR-1-738
39-007 CPS Fan Motor Assembly 110v
39-009 CPS Circuit Breaker 12 amp
41-612 CPS FAN GRILLE 4" MUFFIN CHROME
41-791 CPS THOMAS 520 SERIES HEAD ASSEMBLY
42-195 CPS KNOB PRO-SET PLASTIC ROUND
44-117 CPS CR600 Base Panel
54-102 CPS Fan 6 Blade 6" .625" Diameter Hub
82-108 CPS Grommets 1/4-20 x .5"
AR2788X40 CPS 6 Ft Power Cord 115 Vac
ARXSB115 CPS Solenoid Valve 115 Volt Solenoid And Coil Kit 115 Volt. 1/4" Quick Disconnect terminals 5/64" Orifice 300 PSI MOPD, 115 volt coil.
CASEYEL-A1 CPS Plastic Housing
CR3MANFLD-A1 CPS Manifold Assembly w/Gauges
CR4CMP110-A1 CPS CR400 Compressor Assembly
CPS CR600 Manifold Gauge Assembly replaces the original manifold and gauges. Includes High pressure switch mounted on the back of the manifold. Easy replacement, simply remove handles and knobs from old manifold, remove the manifold from the unit and replace with the new unit and install the knobs again.
CR6CMP110-A1 CPS CR600 Compressor Assembly
CR6COIL-A1 CPS Condenser Coil Assembly
CRH1-A1 CPS Compressor Suction Hose Assemlby CR600
CRH2-A1 CPS Compressor Discharge Hose Assemlby CR600
CRREG-A1 CPS Regulator Assembly
CRXCR1 CPS CR600 Compressor Rebuild Kit, SK520CAR Thomas Compressor Service Kit includes parts and instructions for complete service of your compressor.
CRXCR7 CPS CR600 Compressor Piston Seal Cup 624281
CRXF2 CPS Inlet Fitting Oring Filter Kit
The CRXOS1 CPS Oil Separator provides a simple but effective means to remove small amounts of oil in the recovery stream for cleaner gas. Use in conjunction with a filter drier for even cleaner refrigerant for recharging. Equipped with standard 1/4" flare fittings and an inlet hose. When recovery is complete, simply drain the unit with supplied valve. Includes mounting hardware.
CPS CR Series Recovery Tank Overfill Protection Kit provides a safe means of recovering refrigerant into a cylinder without the worry of overfilling it causing a potetially hazardous situation. Normally the technician would have to be present to safely recover with a scale, now you can hookup and walk away with out fear of overfulling your tank.
Recovery Tank Overfill Protection Kit provides a safe means of recovering refrigerant into a cylinder without the worry of overfilling it causing a potentially hazardous situation. Normally the technician would have to be present to safely recover with a scale, now you can hookup and walk away with out fear of overfilling your tank. When the recovery cylinder reaches 80% capacity, the unit is shut off via a relay in the machine. Simply change cylinders and restart the unit. Works with any size cylinder with a 3-pin Brad Harison Plug and includes a shorting cap for working with tanks without a float.
CRXTOSP1 Tank Overfill Protection Cable Shorting Plug allows the user to override the tank float safety device on most recovery units using a 3 pin brad Harrison cable. Screws in place at the cable end allowing the unit to start. (Always use a scale for accuracy when using this device) 30 & 50 pound tanks should never be filled to a level beyond 80% of tank capacity.
M2XRK CPS Diaphragm Valve Repair Kit Services 2 Valves
MXPV CPS Black Max Piston Valve Assembly (1) Valve Stem
MXPVO CPS Black Max Piston Seal (Services Two Valves)