14-160 CPS Capacitor 470uFD Electrolytic 200 Volt
20-105 CPS AC/DC 25 Amp Silicon Bridge Rectifier
30-480 CPS Cap 1/4 SAE Female w/strap
30-734 CPS High Pressure Gauge 0-55 (kPa Bar)
30-735 CPS Low Pressure Gauge -1-20 (kPa Bar)
35-102 CPS Main Power Switch DPST On-Off
36-014 CPS Solenoid And Coil Kit 115 Volt. 1/4" Quick Disconnect terminals 5/64" Orifice 300 PSI MOPD, 115 volt coil.
37-101 CPS SPDT 220 RELAY
37-105 CPS Relay SPDT, 115 Coil
39-015 CPS Circuit Breaker 10 amp
39-016 CPS Circuit breaker 5 amp
41-612 CPS FAN GRILLE 4" MUFFIN CHROME
41-779 CPS 500CAR / CDR75 HEAD ASSEMBLY
42-195 CPS KNOB PRO-SET PLASTIC ROUND
42-245 CPS KNOB PRO-SET PLASTIC HEX
44-127 CPS CR500 Base Panel
54-105 CPS Fan Blade 4.5"
82-108 CPS Grommets 1/4-20 x .5"
AR2788X40 CPS 6 Ft Power Cord 115 Vac
ARXSB115 CPS Solenoid Valve 115 Volt Solenoid And Coil Kit 115 Volt. 1/4" Quick Disconnect terminals 5/64" Orifice 300 PSI MOPD, 115 volt coil.
CASEYEL-A1 CPS Plastic Housing
CR5CMP110-A1 CPS CR500 Compressor Assembly 115 Volt
CR5CMP220-A1 CPS CR500 Compressor Assembly 220 Volt
CPS CR600 Manifold Gauge Assembly replaces the original manifold and gauges. Includes High pressure switch mounted on the back of the manifold. Easy replacement, simply remove handles and knobs from old manifold, remove the manifold from the unit and replace with the new unit and install the knobs again.
CR6COIL-A1 CPS Condenser Coil Assembly
CRH4-A1 CPS Compressor Discharge Hose Assembly CR500
CRH5-A1 CPS Compressor Suction Hose Assembly CR500
CRXCR2 CPS CR500 Compressor Rebuild Kit 115v, SK500CAR Thomas Compressor Service Kit includes parts and instructions for complete service of your compressor.
CRXCR4 CPS Compressor DC Motor Brush Kit 115v. Brush Spring Leadwire Assembly Red/Black Thomas 650645
CRXCR6 CPS CR500 Compressor Piston Seal Kit
CRXF2 CPS Inlet Fitting Oring Filter Kit
The CRXOS1 CPS Oil Separator provides a simple but effective means to remove small amounts of oil in the recovery stream for cleaner gas. Use in conjunction with a filter drier for even cleaner refrigerant for recharging. Equipped with standard 1/4" flare fittings and an inlet hose. When recovery is complete, simply drain the unit with supplied valve. Includes mounting hardware.
CPS CR Series Recovery Tank Overfill Protection Kit provides a safe means of recovering refrigerant into a cylinder without the worry of overfilling it causing a potetially hazardous situation. Normally the technician would have to be present to safely recover with a scale, now you can hookup and walk away with out fear of overfulling your tank.
Recovery Tank Overfill Protection Kit provides a safe means of recovering refrigerant into a cylinder without the worry of overfilling it causing a potentially hazardous situation. Normally the technician would have to be present to safely recover with a scale, now you can hookup and walk away with out fear of overfilling your tank. When the recovery cylinder reaches 80% capacity, the unit is shut off via a relay in the machine. Simply change cylinders and restart the unit. Works with any size cylinder with a 3-pin Brad Harison Plug and includes a shorting cap for working with tanks without a float.
CRXTOSP1 Tank Overfill Protection Cable Shorting Plug allows the user to override the tank float safety device on most recovery units using a 3 pin brad Harrison cable. Screws in place at the cable end allowing the unit to start. (Always use a scale for accuracy when using this device) 30 & 50 pound tanks should never be filled to a level beyond 80% of tank capacity.
M2XRK CPS Diaphragm Valve Repair Kit Services 2 Valves
MXPV CPS Black Max Piston Valve Assembly (1) Valve Stem
MXPVO CPS Black Max Piston Seal (Services Two Valves)