13067 Robinair High Vacuum Grease is a silcone based lubricant designed for high vacuum assembly applications. A stiff, nonmelting silicone lubricating material used to lubricate synthetic and silicone rubber gaskets being used in high temperature applications. High Vacuum Grease resists mineral oils and common gases and works well for a setting gel to capture o-rings during assembly.

62-124 CPS Power Cord

AR2788X40 CPS 6 Ft Power Cord 115 Vac

1/4" SAE Male Flare  X 1/4" SAE Female Swivel Flare X 1/2" ACME male connector TEE. Used to adapt vacuum pumps or other accessories in the A/C System.

RT200R Refrigeration Technologies NYLOG RED (CFC/HCFC Mineral or AB). NYLOG gasket and thread sealant renders a strong, flexible, lubricative glaze that prevents high pressure leakage through refrigeration gaskets and threaded fittings. NYLOG never hardens and always remains temperature and vibration resilient. Nylog Red is recommended for Mineral or Alkyl Benzene Systems

RT200RP Refrigeration Technologies NYLOG RED (CFC/HCFC Mineral or AB) (2-Pack). NYLOG gasket and thread sealant renders a strong, flexible, lubricative glaze that prevents high pressure leakage through refrigeration gaskets and threaded fittings. NYLOG never hardens and always remains temperature and vibration resilient. Nylog Red is recommended for Mineral or Alkyl Benzene Systems

Dual voltage design vacuum pump operations on 115 VAC or 230 VAC (50 or 60Hz). Advanced two-stage design pulls deep vacuum fast to 15 microns. Single stage design pulls vacuum fast to 100 microns. *Tap into rooftop power with an optional 230VAC jumper cable (VPXJ220).

Dual voltage design vacuum pump operations on 115 VAC or 230 VAC (50 or 60Hz). Advanced two-stage design pulls deep vacuum fast to 15 microns. Single stage design pulls vacuum fast to 100 microns. *Tap into rooftop power with an optional 230VAC jumper cable (VPXJ220).

The CPS VP2D vacuum pump is a great tool to have for the job site. This pump is a dual voltage 115 / 220 Volt switchable power motor. A full 2 CFM deep vacuum pump providing fast pull down to 15 Microns using a 1/4 Horse Power motor. Inlet fittings provide connection of 1/4" Flare 3/8" Flare or 1/2" ACME Automotive Hoses. Unit weight is 22 lbs for greater portability.

6.25 CFM Dual voltage design vacuum pump w/gas ballast valve.  Operates on 115 VAC or 230 VAC (50 or 60Hz). Advanced two-stage design pulls deep vacuum fast to 15 microns.

6CFM Single Stage, Dual Voltage Vacuum Pump.  Operates on 115 VAC or 230 VAC (50 or 60Hz). Single-Stage 6 CFM.

Dual voltage design vacuum pump operations on 115 VAC or 230 VAC (50 or 60Hz). Advanced two-stage design pulls deep vacuum fast to 15 microns. Single stage design pulls vacuum fast to 100 microns. *Tap into rooftop power with an optional 230VAC jumper cable (VPXJ220).

VPBM12V CPS BlackMax 12 CFM Sparkless Vacuum Pump

VPBM8V CPS BlackMax 8 CFM Sparkless Vacuum Pump

VPGXEB4 CPS Vacuum Pump Oil Reservoir Cover

VPGXEH1 CPS Vacuum Pump Power Cord Switch & Cover 115 Volt

VPGXEH2 CPS Vacuum Pump Power Switch & Cover Dual Voltage. Power Cord Sold Separately.

VPGXEH3 CPS Vacuum Pump Power Cord Switch & Cover Single Voltage. Power Cord Sold Separately.

VPGXFB3 CPS Vacuum Pump Fan Blade VP Medium

VPGXFG3 CPS Vacuum Pump Fan Grill VP Medium

VPGXH2 CPS Vacuum Pump Handle

VPGXIP2 CPS Vacuum Pump Intake Tee 1/4" 3/8" Flare 1/2" ACME

VPGXIP3 CPS Vacuum Pump Intake Tee 1/4" 3/8" 1/2" Flare

PRO-SET® Premium Vacuum Pump Oil is an extremely high quality, severely hydrotreated vacuum pump oil. The oil is compatible for use in pumps made by most manufacturers. PRO-SET® Premium Vacuum Pump Oil should always be clean and free of contaminants such as moisture, acids, vapors, dirt etc. It is strongly recommended that the vacuum pump oil be changed after each use to improve service and the life of the pump.

PRO-SET® Premium Vacuum Pump Oil is an extremely high quality, severely hydrotreated vacuum pump oil. The oil is compatible for use in pumps made by most manufacturers. PRO-SET® Premium Vacuum Pump Oil should always be clean and free of contaminants such as moisture, acids, vapors, dirt etc. It is strongly recommended that the vacuum pump oil be changed after each use to improve service and the life of the pump.

PRO-SET® Premium Vacuum Pump Oil is an extremely high quality, severely hydrotreated vacuum pump oil. The oil is compatible for use in pumps made by most manufacturers. PRO-SET® Premium Vacuum Pump Oil should always be clean and free of contaminants such as moisture, acids, vapors, dirt etc. It is strongly recommended that the vacuum pump oil be changed after each use to improve service and the life of the pump.

CPS introduces another addition to the Pro-Set vacuum pump line-up with the VPS series. An efficient, lightweight and reliable vacuum pump, that meets ANSI ignition proof standards. VP12DU CPS 12 CFM Two-Stage 115V Vacuum Pump Sparkless (Ignition Proof). Advanced two-stage design pulls deep vacuum fast to 25 microns. Designed and tested to meet ANSI 12:12.01 Ignition Proof standards. For use on refrigeration systems utilizing Class A1 (nontoxic, nonflammable), Class A2L (nontoxic, low flammability), Class A2 (nontoxic, flammable), and Class A3 (nontoxic, flammable) and Ammonia (NH3). Air cooled, thermally protected motors encased in a durable aluminum housing.

CPS introduces another addition to the Pro-Set vacuum pump line-up with the VPS series. An efficient, lightweight and reliable vacuum pump, that meets ANSI ignition proof standards. VP6DU CPS 6 CFM Two-Stage 115V Vacuum Pump Sparkless (Ignition Proof). Advanced two-stage design pulls deep vacuum fast to 10 microns. Designed and tested to meet ANSI 12:12.01 Ignition Proof standards. For use on refrigeration systems utilizing Class A1 (nontoxic, nonflammable), Class A2L (nontoxic, low flammability), Class A2 (nontoxic, flammable), and Class A3 (nontoxic, flammable) and Ammonia (NH3). Air cooled, thermally protected motors encased in a durable aluminum housing.

includes pump cartridge, reservoir quad seal, mid section o-ring, shaft seal, screen and inlet baffle foam (Seal kit 41-766).

includes pump cartridge, reservoir quad seal, mid section o-ring, shaft seal, screen and inlet baffle foam (Seal kit 41-766).

VPXEB02 CPS End Bell Oil reservoir O-ring Medium 3D 6S 6D (Old Style)

VPXEP1 CPS Electrical Switch Plate VP2S/D VP3S/D VP6S/D. Off / On Switch with fused power cord receptacle and 110 / 220 volt switch.

VPXGB CPS Gas Ballast VP6D (Old Style)

Vacuum Pump Jumper Cord Kit, IEC to Alligator Clips

VPXOF CPS Oil Fill Cap VP4 & VP6 Vacuum Pumps (Old Style Red) Not compatible with newer larger diameter Pump port.

VPXOMP CPS Oil Fill Cap Oil Mist Filter VP4 & VP6 Vacuum Pumps (New Style Black)

VPXOMP2 CPS Oil Fill Cap Oil Mist Filter 8 - 12 CFM Vacuum Pumps

VPXOS CPS Replacement Oil Sight Glass VP4/VP6

VPXPB CPS Foot Base VP4 VP6 (Old Style)

VPXPH CPS Carrying Handle VP4/VP6 (Old Style)

VPXPV CPS Vacuum Pump Inlet Tee Blank Off Valve VP4/VP6 for old style pumps. Includes seal o-ring and ball.