Power Cord 115 Volt 3 Prong. Termination Specs, 1/4" Quick Connect (Black), Ring Terminal (Ground), Stripped Wire (White).

0099000062 Schumacher 6" CW Fan Blade.

Fan Motor Open Frame 115 Volt

0099000096 Knob For Timer Switches 1/4" OD 3/4 "D" Shaft, there are separate knobs for selector switches and timers. Please check your part numbers carefully.

0099000208 Axle 3/8" X 14.5" With Swage

8" Front foot for new style battery chargers. 3.7" Tall, 2.72" hole centers for screws.

0099000228 Axle, 14.5 X 3/8 With Swage

0099000709 Wheel 8" Units 3/8" Axle

4 Position Rotary Switch with hard wire push in connections. (Works with solid or stranded wire, see notes)

Axle End Cap Fits .375 (3/8") Diameter Axle, Sold as a Pair, Can be used on any 3/8" Axle to secure wheels.

Digital Circuit Board functions as a Voltmeter, Ammeter, Amp Hour Accumulator, and Timer. Great for project units as well.

Heatsink Rectifier Assembly 2 Diode design, requires soldering to install. Caution should be used when installing this product and care taken to insure over heating or shorting does not occur while soldering

120 Minute mechanical timer with knob. 120 minute total time. Mechanically controls charging in timed Mode with manual hold mode. Single Pole Single Throw (SPST) Switch rated 15 amperes, finish bell.

Heatsink Rectifier Assembly, requires no soldering to install. Includes 9" leads. Used on newer style units. Heavy Duty design for greater reliability. 1/4" spade terminal leads make installation a snap.

Heatsink Rectifier Assembly, requires no soldering to install. Includes 9" leads. Used on newer style units. Heavy Duty design for greater reliability. 1/4" spade terminal leads make installation a snap. *(fan speed control board sold separately)

Fan Blade 6" 4 Blade CW. Same as 130007-001 Christie

3199100028A 75 Amp 400 Volt Positive Diode (Anode On Lead). Press in diode, used in a wide array of applications. Once installed in the heat-sink these may require soldering to install onto transformer taps.
Use caution when replacing diodes always verify polarity or damage to equipment or self may result. Century Tool & Equipment assumes no responsibility for loss, damage or personal injury due to the miss-application of any electrical component. Purchase of this item agrees to said statement. This item should only be installed by a qualified and experienced electrician.

3599000566 Schumacher Battery Charger Handle Round Steel Chrome, Flat sides

3899000943 Positive Output Cable and Clamp

Output Cable And Clamp, Red Positive, 6 AWG Welding wire, Steel Plasti-cote Clamp, Copper jaws and a ring terminal connection, 72" long.

Output Cable And Clamp, Black Negative, 6 AWG Welding wire, Steel Plasti-cote Clamp, Copper jaws and a ring terminal connection, 72" long.

3999000107 Schumacher Circuit Breaker 32 Volt DC 90 Amp. When ordering, it may be necessary to purchase a pair of the 5199000406 screws if replacing and older circuit breaker for retrofit.

51-288 115 Volt Fan Motor With Fan Blade & Mount. .195 diameter shaft. Your unit may not require the mount, in which case discard it.

5100000005 Screw M3 X 5.5 For Original Timer

5199000406 Schumacher Screw 1/4-28 x 0.375 (Circuit Breaker Connection Screw)

6094K89 Knob For Battery Charger Selector Switches & Timers. This Knob is for selector switches and timers, designed with 1/4" ID and a set screw for locking onto shaft. Suitable for all 1/4" shaft switches. Replaces Schumacher 0099000045 & 0099000096.

TJ1-120MB Universal Mechanical 2 Hour Timer With Finish Bell. Mechanically controls charging in timed Mode, has "Hold" for manual un-timed charging. Single Pole Single Throw (SPST) Switch rated 15 amperes. Termination is designed to accept 1/4" Quick Disconnect terminals. Includes mounting screws. Replaces many older mechanical timers.