0090026121 Schumacher Power Cord. SJTOWA, 14 Gauge 3 conductor 9' long .25" X .25 X RIN Termination

This Knob is for selector switches on SE Series chargers only, there are separate knobs for selector switches and timers. Please check your part numbers carefully.

0099000062 Schumacher 6" CW Fan Blade.

Fan Motor Open Frame 115 Volt

0099000096 Knob For Timer Switches 1/4" OD 3/4 "D" Shaft, there are separate knobs for selector switches and timers. Please check your part numbers carefully.

0099000201 Axle Rod 3/8 X 14.25" Zinc Plated

6" Front foot for new style battery chargers

0099000208 Axle 3/8" X 14.5" With Swage

8" Front foot for new style battery chargers. 3.7" Tall, 2.72" hole centers for screws.

0099000226 Rubber Wheel, 6" Plastic 3/8" Axle

0099000228 Axle, 14.5 X 3/8 With Swage

This Knob is for selector switches with a 3/4 Shaft only, there are separate knobs for timers with a half shaft. Please check your part numbers carefully.

0499000076 7 Position Rotary Switch

Axle End Cap Fits .375 (3/8") Diameter Axle, Sold as a Pair, Can be used on any 3/8" Axle to secure wheels.

Heatsink Rectifier Assembly 4 Diode design, requires soldering to install. Check your unit for size and type, there were several versions of this unit, earlier units are no longer available. Caution should be used when installing this product and care taken to insure over heating or shorting does not occur while soldering. This unit does not include insulators, bolts, nuts or any other hardware. Discontinued See 3199100028A 75 Amp 400 Volt Positive Diode (Set Of 4) individual diodes.

120 Minute mechanical timer with knob. 120 minute total time. Mechanically controls charging in timed Mode with manual hold mode. Single Pole Single Throw (SPST) Switch rated 15 amperes, finish bell.

Heatsink Rectifier Assembly, requires no soldering to install. Used on newer style units. Heavy Duty design for more reliability. 1/4" spade terminal leads make installation a snap. This unit does not include insulators, bolts, nuts or any other hardware.

Fan Motor provides cooling for the unit. 80mm X 80mm X 25mm 12volt DC quite design keeps noise to a minimum. If equipped, check your 2299002070 Schumacher 12volt DC Fan Speed Controller for possible fault as well.

12 Volt DC Dual Fan Motor Control Board. Mounts to the rectifier, fans plug into the board sockets. Requires removal of heat-sink from old board and riveted to this when installing. We recommend the purchase of 240000077 Silicone Heat Transfer Compound for proper heat transfer.

Ammeter Horizontal 0-60 Amp Range features easy snap-in installation, no tools required. Black Charge Rate face. 0-60 Amp range with start. Wire through induction pick-up for greater accuracy.

Fan Blade 6" 4 Blade CW. Same as 130007-001 Christie

3199100028A 75 Amp 400 Volt Positive Diode (Anode On Lead). Press in diode, used in a wide array of applications. Once installed in the heat-sink these may require soldering to install onto transformer taps.
Use caution when replacing diodes always verify polarity or damage to equipment or self may result. Century Tool & Equipment assumes no responsibility for loss, damage or personal injury due to the miss-application of any electrical component. Purchase of this item agrees to said statement. This item should only be installed by a qualified and experienced electrician.

3599000566 Schumacher Battery Charger Handle Round Steel Chrome, Flat sides

Output Cable And Clamp, Black negative, 6 AWG 116.5" Welding wire, Steel Clamp, Ring Terminal Connection.

Output Cable And Clamp, Red Positive, 6 AWG 106.5" Welding wire, Steel Clamp, Ring Terminal Connection.

3999000115 Circuit Breaker Circuit Breaker, Buss Fuse 32 VDC 70 Amp 3000 A Interrupt. When ordering, it may be necessary to purchase a pair of the 5199000406 screws if replacing and older circuit breaker for retrofit.

51-257 Goodall Ammeter Horizontal 0-60 Amp Range With Start (100 Amp)

51-288 115 Volt Fan Motor With Fan Blade & Mount. .195 diameter shaft. Your unit may not require the mount, in which case discard it.

5100000005 Screw M3 X 5.5 For Original Timer

5399100118 Ammeter, 0-100 Amp Range with Charge & Start

5399100145 Schumacher Ammeter 80 Amp With Start (100 Amp) Horizontal Mount. Wire through Induction pickup.

6094K89 Knob For Battery Charger Selector Switches & Timers. This Knob is for selector switches and timers, designed with 1/4" ID and a set screw for locking onto shaft. Suitable for all 1/4" shaft switches. Replaces Schumacher 0099000045 & 0099000096.

TJ1-120MB Universal Mechanical 2 Hour Timer With Finish Bell. Mechanically controls charging in timed Mode, has "Hold" for manual un-timed charging. Single Pole Single Throw (SPST) Switch rated 15 amperes. Termination is designed to accept 1/4" Quick Disconnect terminals. Includes mounting screws. Replaces many older mechanical timers.