8' 6AWG Welding Wire Lead Set with heavy duty polished clamps featuring coated clamp handles. a 50 lb. Jaw Strength provides positive connections and color coded wires make for easy identification. These even have molded strain relief built on the cables. Ring terminal connections make installation a snap.

246-041-666 Universal Selector Knob with set screw for controls with 1/4" Stem. Replaces all knobs with 1/4" diameter shaft. Fits 1/2 shaft and 3/4 style shaft stems.

246-408-000 6 Position Rotary Selector Switch (No Knob). This switch has been modified from the original metal stem design to a plastic stem and the pin locations have changed. Switch should be wired number to number not by tab location.

246-408-666 Rotary Selector Switch 6 Position With Knob. This switch has been modified from the original metal stem design to a plastic stem and the pin locations have changed. Switch should be wired number to number not by tab location. Includes instructions.

246-513-666 Timer Knob (Slotted) Special knob with slotted shoulders for controls with shaft pins.

Test Switch DPDT Momentary 1/4 Spade. OEM Part Every Time

Mechanical Timer controls charging in timed Mode. Single Pole Single Throw (SPST) Switch rated 15 amperes. 120 minute total time with finish bell, two spade terminal connections.

Ammeter Horizontal 0-60 Amp Range features easy snap-in installation, no tools required. Black Charge Rate face. 0-60 Amp range with start. Wire through induction pick-up for greater accuracy.

Power Cord with Current limiting circuit board and leads, Replaces older style boards with resistors

412-749-666 Battery Charger Front Foot

412-751-666 Chrome Battery Charger Handle. Replaces 442-020-166 and other older Century / Solar Handles

413-115-666 Wheels Axle Hub Set. 3/8" OD axle x 13-1/4" long.

442-002-666 Handle With Hardware

442-020-166 Century Battery Charger Handle. Flat side black painted finish.

Quad Force Rectifier Installation Kit, 250 Amp Cycle Duty, 60 Amp Continuous Duty, 8 Diode Ceramic Insulated Spider Design. Replaces Older Daisy Wheel Design. Heavier heatsink provides better heat dissipation for faster recovery during engine start. Longer life.

865-932-666 Voltmeter 0-20 Volt Range Horizontal With Board for volt test

TJ1-120MB Universal Mechanical 2 Hour Timer With Finish Bell. Mechanically controls charging in timed Mode, has "Hold" for manual un-timed charging. Single Pole Single Throw (SPST) Switch rated 15 amperes. Termination is designed to accept 1/4" Quick Disconnect terminals. Includes mounting screws. Replaces many older mechanical timers.